How to Make A Hair Bow

Hello Everyone!
Hair bows are fun to make and it takes couple of minutes to create. You can use Hair bows to yourself or these can make great gifts

southernplate.com

Then let's get started!

Supplies you will need.....

• Ribbon (Here I use grosgrain ribbons. It works best)
• Tread or floral wire
• Large needle
• Hot glue gun or E6000 glue
• Scissor 
• Lighter
• Clip
• ruler

Here I use 1 cm height , 24 inches long grosgrain ribbon. You can adjust the length of the ribbon according to the height.

1st Step

Mark every 3 inches.

 2nd Step

Fold the ribbon in half

3rd Step

Take a pin and stick it through the center

4th Step

Take one side and pierce it throught the center

This is how the 1st loop looks like

5th Step

Continue to make loops

This is how it looks after creating the all loops

6th Step

Check your loops and adjust. Then take the pin out. Tie the center. Here you can wrap up the center by using floral wire or stitch it using threaded needle

Here I use floral wire.

7th Step

Cut off the tails in an angle. Make sure the both tails are at same length. Then seal them using a lighter

8th Step

Apply some hot glue to the back of the bow

9th Step 

Immediately press your hair clip or band into hot glue. Here I use a hair band

10th Step

Tie a single knot in a piece of ribbon. And stick that piece to the bow. The knot should be in front of the bow.

And VOILA!

By

          Arz